Copyright © All rights reserved. Brian Law Design
Share via e-mail Print
Brian Law’s        Woodenclocks

Clock 36 - 24 Hour Clock


Clock 36 has been designed from the outset to run for 24 hours, so a single wind is all that is needed to keep it running all day. There are other clocks in the range that will run for this time but only if incorporating a simple pulley, in this clock the gear train has been designed to achieve this with no extra complexities.

It is a relatively simple and compact clock to construct using a high ratio gear train to reduce the number of gears required, but still maintaining that typical wooden clock mechanical appearance.

It is small enough to be cut on most CNC machines being 340 mm tall and 200 mm wide and can even be 3D printed if required. The clock will run for just over 24 hours if mounted on the wall with the centre of the dial at 1500 mm above the floor

The appearance is slightly quirky as the top of the front frame is offset to give a better view of the Graham escapement working on the large escape wheel, and for the first time in a while I have incorporated a Seconds hand that actually turns the right way without extra gearing.

The prototype for this clock as shown in the attached video was built using 3D printing, due to problems with my CNC machine which will hopefully be overcome for the next clock due later this year.

Drawings for this clock in PDF format can be downloaded here, These free files are low resolution and not to scale and only a sample of the full set that comes in the paid for version. Clicking to the left here will download the PDF file directly to your browser, may take a few moments so please be patient.

A sample from the DXF file is shown when you click on the arrow .The file is purposely low resolution, with no vector data.The actual files purchased above are included on one large sheet so that they may be directly loaded into your CAM program

Clock-36-Detail-drawing-sample.pdf

To print only a single item of the drawing to scale using Adobe Acrobat Reader,  do the following

Go to  Edit  then click on   Take a snapshot

Move the cursor to the top left of the item you want to print and hold down the left mouse button whilst you drag a box around the item.  The inside of the box turns blue and you can now go to  File and then click on  Print  . This brings up the print dialogue, make sure Selected graphic  is selected and that the Page scaling is set to  Actual Size, and Print in grey is ticked,then click on  OK,  .As long as your printer is connected you will have printed the item at size.Do this for each item you want to cut out.

PrinterTips

DXF files, and the IGS and STP files files that can be used with your CNC machine can be downloaded here for $26 You also get the unrestricted version of the PDF files that can be printed at full size and in this clock only the STL files if you need them.

Clock-36-Renders-1.jpg Clock-36-Renders-3.jpg Clock-36-Renders-2.jpg Clock-36-Renders-4.jpg

A sample of the Instructions for assembling the clock components.

Clock-36-Instructions-sample.pdf Clock-36-Profile-cuts-pr.jpg
Clock-36-Web-header.jpg